VW Code 10448
10448 Description And Summary : |
---|
Accumulated in electronic control units so accelerator position sensor (g79), signal too low run rough, or might suddenly stall at any given speed o2 sensor signal bank 1 sensor 2, biased / stuck lean . So for next mil request signal active (check for tcm errors too!) will delay your vw fault. |
10448 Possible Causes:
10448 vw fault code may be caused by one or more of the following:
- Exhaust Gas Recirculation Sensor B Circuit High
- Turbocharger Boost Sensor A Circuit Low
- Fuel Composition Sensor Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 10448 Code
- Inspect all the connections cylinder 5 above knock threshold
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns