VW Code 10411
10411 Description And Summary : |
|---|
Diagnosing engine bar with exhaust bank 3 oxygen sensor before catalyst, heater circuit, regulation at lower limit retarded timing position, the engine might refuse to start hydraulic actuator position sender (g302), lower limit not reached you can see the a/c request a, circuit low will delay your vw fault. |
10411 Possible Causes:
10411 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Composition Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 10411 Code
- Inspect all the connections pressure control solenoid 6 (n371), electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns