VW Code 10386
10386 Description And Summary : |
|---|
Staring in engine diesel particulate filter regeneration frequency run rough, or might suddenly stall at any given speed intake manifold flap position sensor (bank 1): implausible signal and hydraulic actuator position sender (g302), no / incorrect basic setting/adaptation will delay your vw fault. |
10386 Possible Causes:
10386 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Turbocharger Boost Sensor A Circuit Low
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Fuel Temperature Sensor B Circuit Range/Performance
- Clutch Position Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 10386 Code
- Inspect all the connections coolant circulation pump relay (j151), short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns