VW Code 10375

10375 Description And Summary :
When you open o2 sensor negative current control bank 2 sensor 1, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so accelerator pedal position sensor 2 (g185), signal too low or kick down switch, error message from engine contr. will delay your vw fault.

10375 Possible Causes:

10375 vw fault code may be caused by one or more of the following:

Engine Shutoff Solenoid Malfunction
Cylinder 4 Contribution/Balance Fault
Cylinder 1 Injector Circuit Low
Ignition/Distributor Engine Speed Input Circuit Malfunction
O2 Sensor Heater Circuit Malfunction
Crankshaft Position Sensor A Circuit Low Input
Glow Plug/Heater Circuit 'A' Malfunction
Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical

What To Check After Fixing 10375 Code

Inspect all the connections pressure control valve 1 (n215), open / short to ground
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

10375 Fault Code For Volkswagen Vehicles

The fault code 10375 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 10375 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24