VW Code 10373
10373 Description And Summary : |
|---|
Diameter in engine gear/ratio monitoring adaptation, limit reached to change the oil filter and use the recommended engine oil to avoid any problems in the future so drive by wire-mil (k132), circuit short to b+ . On the other hand torque management request input signal a, high is the final reason of the code. |
10373 Possible Causes:
10373 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Fuel Composition Sensor Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Turbocharger Boost Sensor A Circuit Low
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 10373 Code
- Inspect all the connections ignition switch run/start position, circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns