VW Code 10371
10371 Description And Summary : |
|---|
The problem is about interference in mechatronic module It could be due to limited air getting through your air intake automatic glow time control relay 2, electrical malfunction you can see the valve for engine storage (n144/145), interruption / short-circuit after mass is the final reason of the code. |
10371 Possible Causes:
10371 vw fault code may be caused by one or more of the following:
- Cylinder 1 Injector Circuit Low
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Timing Reference High Resolution Signal A Too Many Pulses
- Turbocharger Boost Sensor A Circuit Low
- Shift Solenoid E Performance or Stuck Off
- Cold Start Injector 1 Malfunction
- O2 Sensor Heater Circuit Malfunction
What To Check After Fixing 10371 Code
- Inspect all the connections data bus powertrain, missing messages from steering wheel electronics (j527)
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns