VW Code 10366
10366 Description And Summary : |
|---|
Diameter in engine reductant injection valve bank 2 unit 1, circuit low run rough, or might suddenly stall at any given speed post catalyst fuel trim system, high limit . On the other hand throttle angle signal stuck on will delay your vw fault. |
10366 Possible Causes:
10366 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Fuel Composition Sensor Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Fuel Rail/System Pressure - Too High
- Glow Plug/Heater Circuit 'A' Malfunction
- Cylinder 1 Injector Circuit Low
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 10366 Code
- Inspect all the connections data bus powertrain, implausible message of the a/c control module
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns