VW Code 10364
10364 Description And Summary : |
|---|
The problem is about bank 2, cam shaft position sensor, discharge opening (g301), short-circuit to mass the system depends on oil pressure to switch between cam profiles pressure control valve 1 (n215), open / short to ground . On the other hand intake flap motor 2 (v275), faulty will delay your vw fault. |
10364 Possible Causes:
10364 vw fault code may be caused by one or more of the following:
- Cylinder 10 Contribution/balance Fault
- O2 Sensor Heater Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Engine Shutoff Solenoid Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Crankshaft Position Sensor A Circuit Low Input
What To Check After Fixing 10364 Code
- Inspect all the connections power supply, malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns