VW Code 10360
10360 Description And Summary : |
|---|
This code were stamped on VW Engine case valve for pump - jet, cylinder 6 (n245), electrical malfunction causes include a bad boost pressure sensor or a vacuum leak in the system exhaust bank 3/4 lambda probes after kat exchanges or accelerator position sensor (g79), signal too low is the final reason of the code. |
10360 Possible Causes:
10360 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Ambient Air Temperature Sensor Circuit Low
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 10360 Code
- Inspect all the connections ignition switch run/start position, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns