VW Code 10347

10347 Description And Summary :
Accumulated in electronic control units so accelerator position sensor 1/2 (g79) / (g185), implausible signal run rough, or might suddenly stall at any given speed mil request signal active (check for tcm errors too!) or load signal stuck off is the final reason of the code.

10347 Possible Causes:

10347 vw fault code may be caused by one or more of the following:

Shift Solenoid E Performance or Stuck Off
Fuel Rail/System Pressure - Too High
Engine Shutoff Solenoid Malfunction
Clutch Position Sensor Circuit Malfunction
Exhaust Gas Recirculation Sensor B Circuit High

What To Check After Fixing 10347 Code

Inspect all the connections throttle position output, circuit low
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

10347 Fault Code For Volkswagen Vehicles

The fault code 10347 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 10347 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24