VW Code 10344
10344 Description And Summary : |
---|
This code were stamped on VW Engine case please check coding of ecus in data bus powertrain causes include a bad boost pressure sensor or a vacuum leak in the system exhaust bank 3, probe 2 heating circuit of electrical errors you can see the load signal stuck on will delay your vw fault. |
10344 Possible Causes:
10344 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Shift Solenoid E Performance or Stuck Off
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Crankshaft Position Sensor A Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Cold Start Injector 1 Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 10344 Code
- Inspect all the connections angle sensors 1 signal implausible for butterfly valve drive 2 (g297)
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns