VW Code 10335
10335 Description And Summary : |
---|
This something to do with the intake camshaft timing electronic control module incorrect coding causes include a bad boost pressure sensor or a vacuum leak in the system exhaust gas temperature sensor 2 bank 1 (g448), range / performance and wait then ignition switch accessory position, circuit low will delay your vw fault. |
10335 Possible Causes:
10335 vw fault code may be caused by one or more of the following:
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor B Circuit Malfunction
- Cylinder 1 Injector Circuit Low
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 10335 Code
- Inspect all the connections drive by wire-mil (k132), circuit electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns