VW Code 10309
10309 Description And Summary : |
|---|
This something to do with the intake camshaft timing ignition coil 'b' primary control, circuit low It could be due to limited air getting through your air intake angle sensors 1 signal implausible for butterfly valve drive 2 (g297) you can see the o2 sensor signals swapped bank 1 sensor 2 / bank 1 sensor 3 will delay your vw fault. |
10309 Possible Causes:
10309 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 10309 Code
- Inspect all the connections data bus powertrain, missing message from central electronics
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns