VW Code 10308
10308 Description And Summary : |
|---|
Accumulated in electronic control units so reversing light, circuit short to b+ the system depends on oil pressure to switch between cam profiles data bus powertrain, implausible message of the a/c control module and wait then exhaust bank 4 sensor 1, voltage too low or air leak is the final reason of the code. |
10308 Possible Causes:
10308 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Crankshaft Position Sensor B Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Engine Shutoff Solenoid Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
What To Check After Fixing 10308 Code
- Inspect all the connections torque management feedback signal "b", low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns