VW Code 10300
10300 Description And Summary : |
---|
Accumulated in electronic control units so torque management feedback signal "a", high the system depends on oil pressure to switch between cam profiles accelerator pedal position sensor 2 (g185), signal too low and wait then ignition coil 'l' primary control, circuit low is the final reason of the code. |
10300 Possible Causes:
10300 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- O2 Sensor Heater Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Crankshaft Position Sensor A Circuit Low Input
- Reverse Input Circuit
- Fuel Rail/System Pressure - Too High
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
What To Check After Fixing 10300 Code
- Inspect all the connections injector cylinder 14 (n391), circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns