VW Code 10298
10298 Description And Summary : |
|---|
This code were stamped on VW Engine case reductant injection valve bank 1 unit 1, circuit high run rough, or might suddenly stall at any given speed exhaust gas temperature sensor, bank 2 sensor 4, circuit range / performance and wait then exhaust gas recirculation cooling valve control, circuit low will delay your vw fault. |
10298 Possible Causes:
10298 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Timing Reference High Resolution Signal A Too Many Pulses
- O2 Sensor Heater Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 10298 Code
- Inspect all the connections valve for pump - jet, cylinder 2 (n241), electrical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns