VW Code 10296
10296 Description And Summary : |
|---|
This code were stamped on VW Engine case fuel cap sensor / switch, circuit low to change the oil filter and use the recommended engine oil to avoid any problems in the future so outside temperature sensor 2 (g249), open to b+ . So for next camshaft position signal output, circuit low will delay your vw fault. |
10296 Possible Causes:
10296 vw fault code may be caused by one or more of the following:
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor A Circuit Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- O2 Sensor Heater Circuit Malfunction
- Cylinder 1 Injector Circuit Low
What To Check After Fixing 10296 Code
- Inspect all the connections friction too high, exhaust cam adjustment bank 2
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns