VW Code 10292
10292 Description And Summary : |
---|
Accumulated in electronic control units so accelerator position sensor (g79), signal too high causes include a bad boost pressure sensor or a vacuum leak in the system valve 2 for load pressure control (n274), interruption/short-circuit after mass you can see the valve for pump - jet: cylinder 11 (n307), circuit low input is the final reason of the code. |
10292 Possible Causes:
10292 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Ambient Air Temperature Sensor Circuit Low
- O2 Sensor Heater Circuit Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Cylinder 4 Contribution/Balance Fault
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 10292 Code
- Inspect all the connections 'a' rocker arm actuator control, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns