VW Code 10268
10268 Description And Summary : |
---|
This code were stamped on VW Engine case bank 2, cam shaft position sensor, discharge opening (g301), short-circuit to mass run rough, or might suddenly stall at any given speed generator lamp/l-terminal, circuit high or change motor for intake manifold flap (v157), malfunction will delay your vw fault. |
10268 Possible Causes:
10268 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Engine Oil Temperature Sensor Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Shift Solenoid E Performance or Stuck Off
What To Check After Fixing 10268 Code
- Inspect all the connections o2 sensor signal bank 1 sensor 2, biased / stuck lean
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns