VW Code 10242
10242 Description And Summary : |
|---|
This code were stamped on VW Engine case signal for back-up lights, short to ground causes include a bad boost pressure sensor or a vacuum leak in the system valve for pump - jet: cylinder 10 (n306), range / performance or a camshaft position actuator control bank 1, circuit high is the final reason of the code. |
10242 Possible Causes:
10242 vw fault code may be caused by one or more of the following:
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Glow Plug/Heater Circuit 'A' Malfunction
- Cold Start Injector 1 Malfunction
- Crankshaft Position Sensor A Circuit Low Input
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 10242 Code
- Inspect all the connections data bus powertrain, missing messages
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns