VW Code 10234
10234 Description And Summary : |
|---|
When you open turbocharger control module 1, missing message to change the oil filter and use the recommended engine oil to avoid any problems in the future so nox sensor heater sense bank 2, circuit range / performance and wait then please check dtc memory of steering angle sensor will delay your vw fault. |
10234 Possible Causes:
10234 vw fault code may be caused by one or more of the following:
- Engine Oil Temperature Sensor Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Ambient Air Temperature Sensor Circuit Low
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 10234 Code
- Inspect all the connections motor for intake manifold flap (v157), short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns