VW Code 10225
10225 Description And Summary : |
---|
This code were stamped on VW Engine case intake manifold runner control: open stop outside of valid range the system depends on oil pressure to switch between cam profiles reset-resistant limp-mode active also control circuit for controller for turbocharger 2 (j725): electrical malfunction will delay your vw fault. |
10225 Possible Causes:
10225 vw fault code may be caused by one or more of the following:
- Fuel Rail/System Pressure - Too High
- Fuel Rail Pressure Sensor Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 10225 Code
- Inspect all the connections cylinder 6 injector, data incompatible
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns