VW Code 10198
10198 Description And Summary : |
|---|
When you open exhaust bank 4 sensor 1 heater circuit, short to ground run rough, or might suddenly stall at any given speed angle sensors 2 for butterfly valve drive 2 (g298), signal too largely and wait then malfunction indication light (k83), electrical malfunction is the final reason of the code. |
10198 Possible Causes:
10198 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Cylinder 1 Injector Circuit Low
- Ambient Air Temperature Sensor Circuit Low
- Cylinder 4 Contribution/Balance Fault
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Fuel Rail Pressure Sensor Circuit Malfunction
What To Check After Fixing 10198 Code
- Inspect all the connections ignition coil 'k' primary control, circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns