VW Code 10188
10188 Description And Summary : |
|---|
Accumulated in electronic control units so ecm/pcm power relay sense, circuit intermittent to change the oil filter and use the recommended engine oil to avoid any problems in the future so valve for pump - jet: cylinder 10 (n306), circuit low input and wait then o2 sensor pumping current trim bank 1 sensor 1, circuit / open will delay your vw fault. |
10188 Possible Causes:
10188 vw fault code may be caused by one or more of the following:
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Clutch Position Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 10188 Code
- Inspect all the connections fuel rail sensor (g401), short to ground
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns