VW Code 10158
10158 Description And Summary : |
|---|
When you open transmission temperature control mechanic will need to check all electrical connections in the camshaft sensor ignition switch run/start position, circuit also intake flap motor 2 (v275), no signal is the final reason of the code. |
10158 Possible Causes:
10158 vw fault code may be caused by one or more of the following:
- Fuel Composition Sensor Circuit Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Engine Oil Temperature Sensor Malfunction
- Fuel Rail Pressure Sensor Circuit Malfunction
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 10158 Code
- Inspect all the connections nox trap, efficiency below threshold (bank 2)
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns