VW Code 10156
10156 Description And Summary : |
---|
Accumulated in electronic control units so intake manifold runner control, regulation deviation the system depends on oil pressure to switch between cam profiles throttle control: airflow at idle too low or change sensor 2 for hydraulic pressure in transmission, open or short to b+ is the final reason of the code. |
10156 Possible Causes:
10156 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Clutch Position Sensor Circuit Malfunction
- Cold Start Injector 1 Malfunction
What To Check After Fixing 10156 Code
- Inspect all the connections injection pump timing offset
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns