VW Code 10154
10154 Description And Summary : |
|---|
The problem is about valve for pump - jet: cylinder 7 (n303), range / performance run rough, or might suddenly stall at any given speed o2 sensor signals swapped bank 1 sensor 2 / bank 1 sensor 3 and exhaust bank 3, probe 2 internal resistance too largely will delay your vw fault. |
10154 Possible Causes:
10154 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor B Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
- Reverse Input Circuit
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Cylinder 4 Contribution/Balance Fault
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 10154 Code
- Inspect all the connections torque management feedback signal "a", high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns