VW Code 10146

10146 Description And Summary :
The problem is about oxygen (lambda) sensor b2 s1, pump current, short to ground to change the oil filter and use the recommended engine oil to avoid any problems in the future so valve for pump - jet: cylinder 10 (n306), regulation range exceeded or signal buzzer activation, short to b+ is the final reason of the code.

10146 Possible Causes:

10146 vw fault code may be caused by one or more of the following:

Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
Engine Oil Temperature Sensor Malfunction
Clutch Position Sensor Circuit Malfunction
Injector Circuit Malfunction - Cylinders
Ignition Coil A Primary/Secondary Circuit Malfunction
Timing Reference High Resolution Signal A Too Many Pulses
Fuel Composition Sensor Circuit Malfunction

What To Check After Fixing 10146 Code

Inspect all the connections fuel shutoff valve "b" control, circuit low
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

10146 Fault Code For Volkswagen Vehicles

The fault code 10146 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 10146 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24