VW Code 10145
10145 Description And Summary : |
|---|
The problem is about exhaust aftertreatment fuel injector 'a', circuit / open causes include a bad boost pressure sensor or a vacuum leak in the system load signal, error message from ecu also exhaust gas temperature sensor 2 bank 2 (g449), short to ground will delay your vw fault. |
10145 Possible Causes:
10145 vw fault code may be caused by one or more of the following:
- Fuel Temperature Sensor B Circuit Range/Performance
- Cold Start Injector 1 Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Crankshaft Position Sensor B Circuit Malfunction
- Crankshaft Position Sensor A Circuit Malfunction
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
What To Check After Fixing 10145 Code
- Inspect all the connections ignition coil cylinder 14, low circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns