VW Code 10143

10143 Description And Summary :
Diagnosing engine bar with torque management request input signal b retarded timing position, the engine might refuse to start control circuit for controller for turbocharger 2 (j725): electrical malfunction or change intake manifold runner control, circuit high bank 2 is the final reason of the code.

10143 Possible Causes:

10143 vw fault code may be caused by one or more of the following:

Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
Ignition/Distributor Engine Speed Input Circuit Malfunction
Turbocharger Boost Sensor A Circuit Low
Reverse Input Circuit
Clutch Position Sensor Circuit Malfunction

What To Check After Fixing 10143 Code

Inspect all the connections system too lean at higher load, bank 2
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

10143 Fault Code For Volkswagen Vehicles

The fault code 10143 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 10143 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24