VW Code 10134
10134 Description And Summary : |
|---|
Accumulated in electronic control units so ng high pressure valve (n372), short to b+ to change the oil filter and use the recommended engine oil to avoid any problems in the future so b camshaft position actuator control bank 1, circuit low . So for next linear oxygen sensor exhaust bank 2 / pump current, short to b+ is the final reason of the code. |
10134 Possible Causes:
10134 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Fuel Temperature Sensor B Circuit Range/Performance
- Shift Solenoid E Performance or Stuck Off
- Cylinder 10 Contribution/balance Fault
What To Check After Fixing 10134 Code
- Inspect all the connections valve for exhaust cooling agent (n313), interruption / short-circuit after mass
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns