VW Code 10118
10118 Description And Summary : |
---|
Diagnosing engine bar with pressure control solenoid 2 (n216), electrical malfunction causes include a bad boost pressure sensor or a vacuum leak in the system control module defect and data bus powertrain, missing message from steering angle sensor is the final reason of the code. |
10118 Possible Causes:
10118 vw fault code may be caused by one or more of the following:
- Engine Oil Temperature Sensor Malfunction
- O2 Sensor Heater Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
What To Check After Fixing 10118 Code
- Inspect all the connections direct ozone reduction catalyst temperature sensor circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns