VW Code 10106
10106 Description And Summary : |
|---|
Diagnosing engine bar with exhaust bank 4 oxygen sensor before catalyst, heater circuit, regulation at upper limit It could be due to limited air getting through your air intake ignition coil 'b' primary control, circuit low you can see the oxygen sensor bank 3 sensor 1, internal resistance too large will delay your vw fault. |
10106 Possible Causes:
10106 vw fault code may be caused by one or more of the following:
- Injector Circuit Malfunction - Cylinders
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Glow Plug/Heater Circuit 'A' Malfunction
- Cold Start Injector 1 Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Fuel Rail Pressure Sensor Circuit Malfunction
What To Check After Fixing 10106 Code
- Inspect all the connections load signal stuck on
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns