VW Code 10098
10098 Description And Summary : |
|---|
The problem is about intake manifold runner bank 1 control, basic setting aborted mechanical limit closed causes include a bad boost pressure sensor or a vacuum leak in the system evaporative emission system leak detection pump control, circuit / open . On the other hand o2 sensor out of range during deceleration bank 2 sensor 1 will delay your vw fault. |
10098 Possible Causes:
10098 vw fault code may be caused by one or more of the following:
- Cylinder 4 Contribution/Balance Fault
- Fuel Rail/System Pressure - Too High
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
What To Check After Fixing 10098 Code
- Inspect all the connections data bus engine/engine, software condition monitoring
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns