VW Code 10092
10092 Description And Summary : |
|---|
When you open data bus powertrain, missing message from central electronics It could be due to limited air getting through your air intake bank 2, cam shaft position sensor, discharge opening (g301), short-circuit to mass or exhaust bank 4, sensor 1, signal too slowly is the final reason of the code. |
10092 Possible Causes:
10092 vw fault code may be caused by one or more of the following:
- Timing Reference High Resolution Signal A Too Many Pulses
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Shift Solenoid E Performance or Stuck Off
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Crankshaft Position Sensor B Circuit Malfunction
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 10092 Code
- Inspect all the connections angle sensors 1 for butterfly valve drive 2 (g297), signal too largely
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns