VW Code 10080
10080 Description And Summary : |
|---|
This code were stamped on VW Engine case data bus powertrain, missing message from control module electric parking brake to change the oil filter and use the recommended engine oil to avoid any problems in the future so bank 1, cam shaft position sensor, discharge opening (g300), short-circuit to mass you can see the ecm/pcm power relay sense, circuit intermittent is the final reason of the code. |
10080 Possible Causes:
10080 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Clutch Position Sensor Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Crankshaft Position Sensor A Circuit Low Input
- Cold Start Injector 1 Malfunction
What To Check After Fixing 10080 Code
- Inspect all the connections boost pressure control valve (n249), mechanical malfunction
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns