VW Code 10078
10078 Description And Summary : |
|---|
This code were stamped on VW Engine case 'a' rocker arm actuator control, circuit high run rough, or might suddenly stall at any given speed o2 sensor signal bank 2 sensor 3, biased / stuck rich or turbo/super charger wastegate solenoid c (n388), electrical will delay your vw fault. |
10078 Possible Causes:
10078 vw fault code may be caused by one or more of the following:
- Turbocharger Boost Sensor A Circuit Low
- Fuel Rail/System Pressure - Too High
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Glow Plug/Heater Circuit 'A' Malfunction
- Clutch Position Sensor Circuit Malfunction
- Fuel Composition Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor A Circuit Malfunction
What To Check After Fixing 10078 Code
- Inspect all the connections starter activation, return message terminal 50, implausible signal
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns