VW Code 10073
10073 Description And Summary : |
|---|
Accumulated in electronic control units so linear oxygen sensor exhaust bank 2 / common ground wire, short to ground to change the oil filter and use the recommended engine oil to avoid any problems in the future so camshaft position signal output, circuit low . On the other hand o2 sensor negative current control bank 2 sensor 1, circuit high will delay your vw fault. |
10073 Possible Causes:
10073 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Low Input
- Reverse Input Circuit
- Timing Reference High Resolution Signal A Too Many Pulses
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Crankshaft Position Sensor B Circuit Malfunction
- Turbocharger Boost Sensor A Circuit Low
What To Check After Fixing 10073 Code
- Inspect all the connections a/c refrigerant distribution valve control, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns