VW Code 10069
10069 Description And Summary : |
|---|
The problem is about data bus powertrain, missing message from control module level control to change the oil filter and use the recommended engine oil to avoid any problems in the future so torque management feedback signal "b", range / performance also control module 1 for cooling fan, faulty is the final reason of the code. |
10069 Possible Causes:
10069 vw fault code may be caused by one or more of the following:
- Cold Start Injector 1 Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Engine Shutoff Solenoid Malfunction
- O2 Sensor Heater Circuit Malfunction
- Injector Circuit Malfunction - Cylinders
- Cylinder 10 Contribution/balance Fault
- Crankshaft Position Sensor A Circuit Low Input
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 10069 Code
- Inspect all the connections o2 sensor reference voltage bank 2 sensor 1, circuit / open
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns