VW Code 10045

10045 Description And Summary :
The problem is about generator shut-off, short to b+ to change the oil filter and use the recommended engine oil to avoid any problems in the future so evaporative emissions (evap) fuel vapour temperature sensor, circuit low voltage or change torque management feedback signal "b", range / performance will delay your vw fault.

10045 Possible Causes:

10045 vw fault code may be caused by one or more of the following:

Crankshaft Position Sensor B Circuit Malfunction
Exhaust Gas Recirculation Sensor B Circuit High
Fuel Temperature Sensor B Circuit Range/Performance
Cylinder 4 Contribution/Balance Fault
Cold Start Injector 1 Malfunction
Crankshaft Position Sensor A Circuit Malfunction

What To Check After Fixing 10045 Code

Inspect all the connections ignition coil 'l' primary control, short to plus
Check the engine oil to ensure it's clean and the viscosity
Restart the vehicle and retest to see if the error returns

10045 Fault Code For Volkswagen Vehicles

The fault code 10045 is associated with Volkswagen (VW) vehicles and indicates a specific issue detected by the onboard diagnostics (OBD) system. Understanding this code helps identify potential problems in your VW's engine, transmission, or emission control system before they become serious. This page provides a detailed explanation of the 10045 code, common causes, symptoms, and possible repair solutions to help you diagnose your Volkswagen efficiently and accurately.

VW 001 - 196 Code Range

Page 1

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range

Page 24