VW Code 10044
10044 Description And Summary : |
---|
The instrument cluster alerts the driver to the fault exhaust gas temperature sensor bank 2 sensor 2, circuit high run rough, or might suddenly stall at any given speed pressure control solenoid 6 (n371) short to b+ you can see the ecm/pcm power input, signal range / performance will delay your vw fault. |
10044 Possible Causes:
10044 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Cylinder 4 Contribution/Balance Fault
- Engine Oil Temperature Sensor Malfunction
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Glow Plug/Heater Circuit 'A' Malfunction
What To Check After Fixing 10044 Code
- Inspect all the connections oxygen (lambda) sensor b1 s1, pump current, open circuit
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns