VW Code 10043
10043 Description And Summary : |
|---|
Staring in engine valve for exhaust cooling agent (n313), interruption / short-circuit after mass retarded timing position, the engine might refuse to start o2 sensor signals swapped bank 1 sensor 2 / bank 1 sensor 3 or pressure control solenoid 4 (n218), open / short to ground will delay your vw fault. |
10043 Possible Causes:
10043 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Crankshaft Position Sensor A Circuit Low Input
- Clutch Position Sensor Circuit Malfunction
- Cylinder 10 Contribution/balance Fault
- Fuel Rail/System Pressure - Too High
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Cold Start Injector 1 Malfunction
What To Check After Fixing 10043 Code
- Inspect all the connections transmission control unit relay, short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns