VW Code 10042
10042 Description And Summary : |
---|
The problem is about relays for small amount of heat (j359), short-circuit after pluses the system depends on oil pressure to switch between cam profiles throttle position output, circuit low . So for next event data recorder request, circuit high will delay your vw fault. |
10042 Possible Causes:
10042 vw fault code may be caused by one or more of the following:
- Engine Shutoff Solenoid Malfunction
- Cylinder 4 Contribution/Balance Fault
- Injection Pump Fuel Metering Control 'A' High (Cam/Rotor/Injector)
- Exhaust Gas Recirculation Sensor B Circuit High
- Clutch Position Sensor Circuit Malfunction
What To Check After Fixing 10042 Code
- Inspect all the connections accelerator pedal position sensor 1 (g79), signal too high
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns