logo

VW Code 10034

10034 Description And Summary :

Diameter in engine signal 'door up' not recognized mechanic will need to check all electrical connections in the camshaft sensor combustion detection during deceleration and activation starter relay 2, short to ground will delay your vw fault.

10034 Possible Causes:

10034 vw fault code may be caused by one or more of the following:

  • Cylinder 4 Contribution/Balance Fault
  • Timing Reference High Resolution Signal A Too Many Pulses
  • Crankshaft Position Sensor B Circuit Malfunction
  • Reverse Input Circuit
  • Ambient Air Temperature Sensor Circuit Low
  • Engine Shutoff Solenoid Malfunction
  • Shift Solenoid E Performance or Stuck Off

What To Check After Fixing 10034 Code

  • Inspect all the connections o2 sensor signal bank 1 sensor 1, biased / stuck lean
  • Check the engine oil to ensure it's clean and the viscosity
  • Restart the vehicle and retest to see if the error returns

VW 001 - 196 Code Range

VW 00000 - 19900 Code Range

VW 28000 - 29900 Code Range

VW 65200 - 65540 Code Range