VW Code 10027
10027 Description And Summary : |
|---|
This something to do with the intake camshaft timing ignition switch run position, circuit high causes include a bad boost pressure sensor or a vacuum leak in the system valve for pump - jet, cylinder 6 (n245), electrical malfunction also actuator supply voltage "b", circuit /open will delay your vw fault. |
10027 Possible Causes:
10027 vw fault code may be caused by one or more of the following:
- Clutch Position Sensor Circuit Malfunction
- Crankshaft Position Sensor B Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
- Timing Reference High Resolution Signal A Too Many Pulses
- O2 Sensor Heater Circuit Malfunction
- Engine Shutoff Solenoid Malfunction
What To Check After Fixing 10027 Code
- Inspect all the connections egr system, regulation range not reached
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns