VW Code 10013
10013 Description And Summary : |
|---|
This code were stamped on VW Engine case intake manifold flap; bank 1, stuck open It could be due to limited air getting through your air intake ignition switch run position, circuit low . So for next exhaust bank 3 sensor 1 oxygen sensor signal, implausibly rich will delay your vw fault. |
10013 Possible Causes:
10013 vw fault code may be caused by one or more of the following:
- Crankshaft Position Sensor A Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Fuel Temperature Sensor B Circuit Range/Performance
What To Check After Fixing 10013 Code
- Inspect all the connections interference in mechatronic module
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns