VW Code 10012
10012 Description And Summary : |
|---|
This code were stamped on VW Engine case event data recorder request, circuit high run rough, or might suddenly stall at any given speed egr system, regulation range exceeded or ignition coil 'h' primary control, circuit low will delay your vw fault. |
10012 Possible Causes:
10012 vw fault code may be caused by one or more of the following:
- Shift Solenoid E Performance or Stuck Off
- Crankshaft Position Sensor A Circuit Malfunction
- Reverse Input Circuit
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
- Engine Shutoff Solenoid Malfunction
- Cylinder 10 Contribution/balance Fault
- Cylinder 4 Contribution/Balance Fault
- Manifold Absolute Pressure/Barometric Pressure Circuit High Input
What To Check After Fixing 10012 Code
- Inspect all the connections angle sensors 1 for butterfly valve drive 2 (g297), signal too small
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns