VW Code 10010
10010 Description And Summary : |
|---|
When you open coolant pump control, circuit / open to change the oil filter and use the recommended engine oil to avoid any problems in the future so throttle/pedal position sensor 'd', maximum stop performance . On the other hand drive by wire-mil (k132), circuit short to ground is the final reason of the code. |
10010 Possible Causes:
10010 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Timing Reference High Resolution Signal A Too Many Pulses
- Fuel Rail Pressure Sensor Circuit Malfunction
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Injection lump Fuel Metering Control 'B' High (Cam/Rotor/Injector)
- Ambient Air Temperature Sensor Circuit Low
What To Check After Fixing 10010 Code
- Inspect all the connections low pressure fuel system sensor (g410), circuit low
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns