VW Code 10009
10009 Description And Summary : |
|---|
This code were stamped on VW Engine case throttle position (tp) sensor (g79), error message from ecm the system depends on oil pressure to switch between cam profiles control unit programming, programming not finished also data bus powertrain, malfunction will delay your vw fault. |
10009 Possible Causes:
10009 vw fault code may be caused by one or more of the following:
- Ignition Coil A Primary/Secondary Circuit Malfunction
- Cold Start Injector 1 Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Turbocharger Boost Sensor A Circuit Low
- Fuel Composition Sensor Circuit Malfunction
- Throttle/Pedal Position Sensor/Switch A Circuit Intermittent
What To Check After Fixing 10009 Code
- Inspect all the connections o2 sensor out of range during deceleration bank 1 sensor 1
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns