VW Code 10005
10005 Description And Summary : |
|---|
The problem is about exhaust gas recirculation throttle control, circuit 'a' low run rough, or might suddenly stall at any given speed actuator supply voltage "b", circuit low also hydraulic actuator position sender (g302), upper limit exceeded will delay your vw fault. |
10005 Possible Causes:
10005 vw fault code may be caused by one or more of the following:
- Glow Plug/Heater Circuit 'A' Malfunction
- Engine Shutoff Solenoid Malfunction
- Shift/Timing Solenoid Malfunction/ 3-2 Shift Solenoid Circuit Electrical
- Ignition/Distributor Engine Speed Input Circuit Malfunction
- Fuel Rail/System Pressure - Too High
- Reverse Input Circuit
- Ignition Coil A Primary/Secondary Circuit Malfunction
What To Check After Fixing 10005 Code
- Inspect all the connections oxygen (lambda) sensor b1 s1, pump current, short to b+
- Check the engine oil to ensure it's clean and the viscosity
- Restart the vehicle and retest to see if the error returns